Help With the Wax-Melter for a newbie

[crazycacti]

Hey there! I bought a presto pot and was all ready to get the supplies needed and make my pot this weekend-following the directions on this website. The directions call for 3/8" pieces-nipple, elbow, and valve-which were not difficult to locate.

It also called for a 19/32" drill bit and a thread tap. We were unable to locate these dimensions at either Lowe's or Home Depot-our local hardware stores.

Does anyone have a helpful suggestion regarding possibly using 1/4 or 1/2 inch pieces and what size drill bit/thread tap one would need-if these sizes may be more accessible? Or where one would get there hands on the original desired sizes!

I have purchased new waxes and am dying to try them out!

Thanks!!

[scentsationaldelites]

I too use the presto pots for melting wax. It isn't necessary to have the pouring taps in the pot to start your candlemaking, especially if you're anxious like I was to get started .

You can pour the melted wax from the pot into a heated 4-6 cup glass measuring cup then pour into your molds or containers.

I remember having a difficult time finding the right sizes when I looked for them also.

Good luck to you!

Ann

[Freezin]

I have one presto with a tap and one without. I prefer my one without. It is just easier for me to pour into my pour pot. I haven't had any problems doing this for the past 2 1/2 years.

[terryb44256]

i have 2 presto pots... couldnt wait either to use them so i didnt put any valves in and now i dont miss them... i use a ladle to put the wax in the pour pot where i mix my colors and scents and pour from there...

[pinetreecandles]

You don't really need to have a spout, but if you want one, you might take a look at the link below. It's directions for making one, but uses different parts and a more common size bit.

http://www.candlecauldron.com/prestopot.html

Good luck!

[Everito Bandito]

My guess is that you will find that 19/32 drill bit and tap at either a NAPA auto parts store or Sears.

Also 1/4" may be too small and easier to clog. The 1/2" may require a 1/2 drill instead of a 3/8 unless you use a 1/2" spade bit - which is made for wood. A spade bit may cut the presto pot material just fine - however a spade bit may want to knock around a good bit more and could gouge the metal.

But then that JB weld mentioned in the linked article is some pretty good stuff if you decide to go that route.

[crazycacti]

Thanks so much-am checking it out!!

[crazycacti]

Thanks!!

[LITTLEOX]

I don't have a spout on mine either. I just put a little bit of water in mine and set the pouring pot in it.