chauntelle Posted September 26, 2006 Share Posted September 26, 2006 I made a pillar candle and lite it 24hrs after and the flame was 2 inches high. I measured the wick b4 lighting and i haven't used any FO. Is this too high?? tried it again and it's done the same thing. what am i doing wrong???? Quote Link to comment Share on other sites More sharing options...
Mozzie Posted September 26, 2006 Share Posted September 26, 2006 I asked the same question quite a few months ago plus posted a photo and was told in no uncertain terms that my flame could be used to light a bbq. LOL. You're not doing anything wrong, just try a smaller wick. Quote Link to comment Share on other sites More sharing options...
chauntelle Posted September 26, 2006 Author Share Posted September 26, 2006 thankyou for putting my mind at rest, i did try to do a search but didn't mind an answer. will give ur suggestion ago!! Quote Link to comment Share on other sites More sharing options...
Everito Bandito Posted September 26, 2006 Share Posted September 26, 2006 I use a wick in my pillars that makes the pillar burn good, from top to bottom. I don't have to hug the candles. When the flame get's taller than I like for it to be, I put out the flame and trim the wick short. Re- light it and let it burn some more.. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.