Debk Posted November 23, 2008 Share Posted November 23, 2008 I can't get the starburst pillar out of the aluminum mold!!! Any suggestions out there please? Quote Link to comment Share on other sites More sharing options...
Stella1952 Posted November 23, 2008 Share Posted November 23, 2008 Put the mold into the refrigerator for a while and see if it will just slide out. If not, turn upside down and run warm water over the mold - it should slide out.Did you use any palm stearic acid? Helps a lot with demolding. Quote Link to comment Share on other sites More sharing options...
Debk Posted November 23, 2008 Author Share Posted November 23, 2008 no, i didn't use any palm steric but i do have some. I will try to sit it in a hot bath or else heat gun it lol thanks for your tips Quote Link to comment Share on other sites More sharing options...
Stella1952 Posted November 24, 2008 Share Posted November 24, 2008 CAREFUL with the heat gun - it can destroy the pattern! Quote Link to comment Share on other sites More sharing options...
Debk Posted November 25, 2008 Author Share Posted November 25, 2008 well, warmed up the oven stuck it in and melted some of it to get it out. still turned out nice believe it or not, lol. The feather wax slides right out of my metal molds so going to just use feather wax instead of the starburst. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.