My first candle! It is a Soy Container Candle with an ECO-14 6" wick. Everything seems to be working the way that it should, BUT... during my third test burn, it is evident that my wick is no longer centered. The wick appeared to be centered BEFORE the pour, AFTER the pour, during cooling/curing, and during my first two test burns (four hours each). The candle is burned down approximately one inch at this point. My wick is DEFINITELY NO LONGER CENTERED. I tried to use a wick bar to stabilize the wick during cooling. I was unable to use the wick bar in the way in which it was designed to be used. My wick was too thick to slide into the slit on the wick bar. In desperation, I tried to stabilize the wick by wedging it between two wick bars (one bar on each side, with the wick in between). Obviously, that method did not stabilize the part of the wick within the cooling wax. Does anyone have any suggestions on how to stabilize my wicks while maintaining tension on the wick (during cooling) to prevent it from "bending" in the hot wax? Please, please have a simple solution... )